Common Methods And Precautions For Acrylic Display Stand Bonding

There are many ways to glue acrylic display stands. The next steps take you to know what method, and what you should pay special attention to:

1. Connection: Place the two pieces of acrylic display stand to be connected horizontally on the actual operating platform, and stick tape on the bottom end, leaving a gap no more than 0.3 mm wide for applying adhesive.

2. Facade bonding: Facade bonding is the most commonly used bonding process. First, wipe the surface to be bonded, use the model to complete the bonding, and keep the adhesive fixed, which is conducive to improving the bonding strength of acrylic display stands. quality.

3. Surface bonding: clean and tidy the surface of the bonded acrylic display stand, inject an appropriate amount of adhesive, place one side of another acrylic display stand at an angle, touch the acrylic display stand coated with adhesive, and then evenly Lower slowly to drive air bubbles from one side to bond.

Acrylic display stand adhesive will corrode the surface of the acrylic sheet and leave an indelible mark, so it can be held in place without tape. Vegetable oil, dust, or air vents can prevent the adhesive from distributing evenly and leave air bubbles. Direct blowing will whiten the edges of the bonded surfaces due to the volatilization of the adhesive. In addition, indoor humidity and temperature also have a direct impact on acrylic bonding.